All prices are in All prices are in USD
Minn Kota PowerDrive 12 to 24 Volt Conversion Kit (No AutoPilot)
For Use With:
- Minn Kota PowerDrive 50 / 12 Volt Models (2001 & Newer)
- Minn Kota PowerDrive 55 / 12 Volt Models (2001 & Newer)
This kit includes everything needed to convert a 12 Volt
Minn Kota PowerDrive Motor to 24 Volts.
Kit Includes:
1 - Control Board (2884056)
1 - Armature (92-100-128)
1 - MKP-32 Prop (1878131 / 2091160)
1 - Brush Plate (9-738-038)
1 - Seal Kit (2888460)
2 - Brush Spring (975-042)
2 - Brush (188-038)
2 - Brush Plate Screw (830-007)
1 - Magnet Housing (92-200-005)
2 - Nylatron Washer (990-070)
1 - Steel Thrust Washer (990-067)
1 - E-Clip (788-015)
2 - Thru Bolt (830-008)
NOTE:
This Conversion Kit WILL WORK with PowerDrive Models
equipped with I-Pilot or Advanced GPS.
This Conversion Kit WILL NOT WORK with PowerDrive Models
equipped with AutoPilot.
For models equipped with AutoPilot, Order the kit below:
Minn Kota PowerDrive 12 Volt to 24 Volt Conversion Kit (AutoPilot)
Posted by Chris G. on Jul 1st 2025
This review is for the Minn Kota Powerdrive 12V to 24V conversion kit, i-Pilot:
My Minn Kota PowerDrive v2, back before the conversion to 24V, always struggled to hold in current. Any current over 2-3mph was a lost cause. My boat was too large for a 12V trolling motor, I hadn't realized there was a conversion kit until I discovered it on trollingmotorparts dot com. The whole conversion takes under 25 minutes, and it's very easy, even though it may seem daunting. I would encourage anyone feeling underpowered at 12V to convert to 24V. A new 24V trolling motor easily costs over $2k. This conversion kit is just a fraction of the cost. It was a no-brainer to bump up to 24V. I replaced my 12V trolling motor battery with a 24V 100Ah lithium battery, runs my 24V-converted PowerDrive v2 for 2 full days of fishing before needing a recharge.
All prices are in USD. © 2025 Trollingmotorparts.com. Sitemap | Shopping Cart Software by BigCommerce