Loading... Please wait...
- Home
- Minn Kota
- Minn Kota Parts (by Category)
- Minn Kota Motor Ramp / Skid Plate Kit (Terrova/Riptide)(80lb.)(Bluetooth)
Product Description
Minn Kota Motor Ramp / Skid Plate Complete Rebuild Kit
Terrova / Riptide Terrova
BLUETOOTH (2017 & Newer Models)
Motor Ramps on this kit will only fit Bluetooth Models.
Fits 4" Diameter Lower Units
80 lb. Thrust / 24 Volt Models
Kit Includes:
1 - Motor Ramp - Left (2323935)
1 - Motor Ramp - Right (2323930)
1 - Skid Plate - Left (2321925)
1 - Skid Plate - Right (2321920)
2 - Aluminum Anodized Stand-Off (2322921)
4 - Rubber Rest Pad (2325115)
4 - Washer #8 .50 OD / .188 SS (2321706)
2 - Washer #10 SS (2321700)
4 - Screw #8-18 X .25 PPH SS (2323412)
2 - Screw #10-24 X .25" PPH SS MCH (2323422)
2 - Screw 1/4-20 X.375 MCH SS CRPH (2323403)
2 - Screw 1/4-20 X 1/2" MCH SS (2323405)
1 - Stand-Off Screw Upgrade Kit Instructions (2882921)
For Use With:
- Minn Kota Terrova 80 lb. Thrust / 24 Volt Bluetooth Models
- Minn Kota Riptide Terrova 80 lb. Thrust / 24 Volt Bluetooth Models
For 55 lb. Thrust Models, Click the Link Below:
Minn Kota Motor Ramp / Skid Plate Kit (Terrova/Riptide)(55lb.)(3.625")
For 112 lb. Thrust Models, Click the Link Below:
Minn Kota Motor Ramp / Skid Plate Kit (Terrova/Riptide)(112lb.)(4.5")
Product Reviews
-
PERFECT FIT
Posted by Ken Sharp on Mar 19th 2024
I removed the damaged parts and compared them to the new parts and they fit perfectly.. All of the needed hardware is included in the kit. The only other thing needed is red Lock tight that is readily available and a small propane torch was used. The overall job was simple after I split and removed the broken latch and then heated up the bushing to loosen the lock tight.
-
retrofit is an improvement in design
Posted by Unknown on Oct 13th 2023
My Terrova had quit locking in place when deployed. I noticed that one of the guidepins had broken on one side. The part was plastic. Ordered the new kit and was pleased that the broken part had been redesigned, and replaced with metal pins, called stand-off screws. The only issue I had was that I could not figure out how to remove the old motor ramps as there was no way to keep the fastener from spinning when trying to unscrew it. In the end I left the old motor ramps in place and just replaced the upgraded skid plate kit. Works great now.
(80lb.)(Bluetooth), $22.95 (https://trollingmotorparts.com/minn-kota-motor-ramp-skid-plate-kit-terrova-riptide-80lb-bluetooth/))